Review on ICT Billet Compatible Connector WACAM30 48 by Ranjit Ghosh

I need an extension cable to connect the camera signal, I installed the wiring harness and the wires were reversed, the car would not start, then I checked the wiring, the middle wire is ground and 12v Power and signal are outside. So to expand the same Gen3 sensor, they are swapped out. In the first picture I hold the end of the sensor in the same orientation. I only had to swap one ending if that was what it was supposed to be. It seems to be a transition from Gen 3 to Gen 4. So if you're using it as a Gen 3 extension, all you have to do is swap the wires. As a gen4 sensor expansion, it should be Sauce