Review on 🔌 10-Feet Cable SHD Monitor Laptop Projector by Jason Wesley

I'm a radio amateur and I needed a long multicore shielded control cable to run my mast to the N7DDC tuner on my antenna. It was an economical choice, but it meant cutting off the ends of the VGA connectors and soldering them to the wires inside. My report only refers to the inner workings of the cable. On a scale of 0 to 10, where 0 is bad chinese junk and 10 is Beldon, I would rate this cable an 8.3 internal conductors, each with double shielding (foil and braid). In addition, the entire cable is heavily shielded. The shell is made of high quality PVC, and the wire insulation is also made of good plastic. Wire size could be heavier, but I feed pairs of 40 amp plugs into 12 volt automotive relays with this. This is a coil current of 350 mA measured at 13.8 VDC on one line in this cable.73.