Review on EMAX Tinyhawk 2 Freestyle BNF: High-performance 2.5 Inch FRSKY FPV Drone with 2s, 200mw VTX, and 7000KV RunCam Nano2 by Jessica Turner

You can't build a quad at this price, it's a great price!. Runcam nano2, 200mW video transmitter, receiver, 2 batteries and carrying case. Tips: 1. The easiest way to bind to your frsky transmitter is to put the transmitter in bind mode. Connect the quad to Betaflight, go to the command line, type bind_rx. Wait about 15 seconds and type save. That's all. Speaking of Betaflight, vtx tables are already loaded in this quad so you can go to the vtx tab and change mw from the default 25 to 200 if you like, or use smart audio from your controller. Without pressing tiny buttons.2. The receiver antenna is a floppy disk and plugs into your props. As shown in my drawing, I placed a small piece of shrink wrap over it, waved it down, and then zipped it in place. I also added a silicone mat for the battery and tied it to hold the batteries in place. more batteries, you will need them. Either take more than 1s and start the dual, or take 2s batts and switch the connector to xt30.