Review on Rentliv Tilting TV Wall Mount Bracket for 37-70 Inches TVs | MAX VESA 600x400mm | Holds up to 132 LBS | Fits 16", 18" and 24" Wood Studs | Low Profile TV Holder by Derek Dolla

I used this to install a 55 inch TV. One issue I had was that my cleats were 24 inches on center. If I mounted the two-stud mount, it would have been too far and I couldn't have placed the TV where I wanted. The real issue of course was where I was going to mount the TV - it's pretty much centered on the stud and doesn't cover the studs on either side so it's not really the bracket's fault. I ended up screwing the bolts into the top and bottom of the B-pillar and the molybdenum bolts into the drywall at the ends to keep the brace flat. It's strong enough. Another issue is the screws used to attach the TV to the brackets. There are two lengths - one too long and one too short for my TV. I ended up using the long ones with three washers from the kit - two thick and one thin. I wanted to make sure I wasn't over tightening the screws. If you're going to hang the TV, it's a good idea to pull the mount's tilt mechanism all the way out - this makes it much easier to attach the TV to the mount. It can be tilted back after hanging.