worked on repairing an atwood gc10a-4e water heater. I installed them in about 15 minutes. It comes with tank mounted sensors and a foam cap. I couldn't be happier. They take a while to fit into their respective holes, but once installed they work great. Don't forget to place the t-stat so that the smaller electrical protrusions on the right side are facing the heater from the outside. A quick way to install them is to remove the old sensor and gently pry outward on the three tabs on the tank. Install the new sensor and with the clear plastic ring under the three tabs, press firmly on the three tabs with a screwdriver. This greatly simplifies installation.
Protect Your RV With LATCH.IT Shade: 7'X9' Zippered Screen Awning For Ultimate Wind Protection And Privacy.
15 Review
12V DC Electric Trailer Jack - 2000Lb Lift Capacity With Hard-Wire Connection
12 Review
RV Outdoor Mat: LATCH.IT 5X8 Boho Style Reversible Rug Ideal For Camping & Camper Use – The Ultimate RV Patio Rug For All Occasions!
30 Review
3 Pack 18" LATCH.IT RV Step Covers For Camper And RV Stairs - Fits 8-11" Depths - Keep Your RV Clean With Step Rugs
17 Review