Review on Baomain Industrial Signal Warning Indicator by Joshua Castillo

I had to buy them to understand the wiring diagram. The schematic on the box does not fully describe the wiring details. After testing, the box's circuit works, but the light is very dim, except for the green LED. The box also describes other light poles with different light colors (blue and white) and gives the colors of the wires. I couldn't decide which wiring scheme to use as many wires of the same color were missing from the light pole. The wiring is detailed on the packaging as follows: Gray with red = dim red LED Gray with orange = very faint yellow LED Bright gray with green = bright green LED Gray with purple = buzzer on For best results under intended use, use the following wiring configurations: Wiring STEADY ON: Red (with a pair of black wires) = Red - Power + for Red (Negative), Yellow (Minus), Green - (Negative), and Purple - (Minus) Red - Switched to Power - (Ground) = Bright Red LED on Yellow - switched by Power- (ground) = Bright Yellow LED on Green - switched by Power- (ground) = Bright Green LED on Violet - switched by Power- (ground) = Buzzer on (buzzer is more like tweeter, like tweeter keys on a piano right side) Gray and black wires = unused STOP-ON wire DC: red (with black wire pair) = red constant power+ and black constant power- (ground) red-on with gray wire = bright red LED flashing on/off Yellow-an with gray A der = bright yellow LED flashing on/off Green - on with gray wire = bright Green LED flashing on/off Violet - toggled by gray wire = buzzer on/off intermittently Gray wire = used as an intermittent signal to earth Also: length (only light pole): 12.250 in diameter: 1.968 in . Light pole support stud threads: 16mm x 1.5mm with contact threads 15mm deep. The 5/8" diameter hole must match the mounting hole snugly if you are not using the included hardware. Mounting hardware is also included: 2 zinc plated steel thin nuts (16 x 1.5), 9.75+ inch hollow aluminum tubing, zinc plated steel mounting bracket and zinc plated steel washer with 16mm hole. The wires run approximately 24 inches from the base of the light tower. I hope this helps anyone looking for these specs for this light pole.