🔌 High-Quality Black Xenon 120V Puck Slim-Line Hardwire Box - American Lighting with Two Molex Outlets and On/Off Switch Review

Good quality and gets the job done with a low profile that slides easily under a cabinet. There were Theo connectors for the lighting set and a perforation for the house's electrical cord. As others have said, it fits fine inside, but if you cut the wire at home and use small plugs you should be able to hook the whole thing up with little effort.

Although others said the wiring in the box is hard to come by, I had no problems. I believe the key is not to have too much extra cable in the box. In any case, be careful not to drop the Molex connectors into the box. I would leave the box open until all the wires are routed (including Molex connections) and then seal it after checking.

The size on the picture looks much larger than the actual package. The box fits in the palm of your hand - very tight packaging. There is no ground wire, and the wires are stranded rather than the solid wires typical of American home wiring. Easy installation, except for the lack of a ground wire.

I bought this product with the matching 120v xenon bulbs They appear to be a quality product and have everything you need to bring light into your home bring to. I sent them back because of the high power consumption. The light box is designed for 120 V and 5 amps. Most household lighting is on the 15 amp circuit. To run two of these (my cabinets are separated by a sink) I would need 10 amps of my kitchen lighting circuit! I don't want to run a custom circuit for a simple under cabinet light so