🌀 ANVISION DC 24V 40mm x 10mm Brushless Cooling Fan: Dual Ball Bearing Technology - YDM4010B24 Review

installed in stock ender 3 hot end box. just fits well. had to be soldered into the wiring harness. it is slightly quieter than the standard hotend fan. However, this decline comes at a cost. the sound is higher and generally more disturbing. I'll try to get over it quickly.

I bought this to upgrade my Ender 3's fan. I chose this fan because it is 24V and would have been easier to install than a traditional fan. noctua. I measured the decibels of this fan compared to the stock Ender 3 fan and found it to be about 5 decibels quieter on average (measured at 1 inch and 1 meter). All in all, a good buy if your stock Ender 3 fan broke and you want to buy something quieter with the same airflow and replace immediately. I also bought a 40mm Orion fan, which is also 24V…

This fan is much quieter than the standard fan on my A350 PSU. I printed a modified backplane and this fan fits perfectly. Just make sure the pin wires match the correct points on the connector. I had to swap the red and black wires in the included 2 pin connector to get the power to work.

**If you plan to mount this in the fursuit muzzle, get AT LEAST an 80x80mm fan as 40 won't do much** (otherwise it was great! I just bought the wrong size and I suppose that's the main problem. although I will say it's not as strong as I thought)