💡 Cablecc ATX 8Pin Female to 8pin Male 180° Angled Power Adapter for Desktop Graphics Card: Efficient Cable Solution Review

I ordered 3 packs of two so I can connect my 3080 in a tight enclosure. Maybe I'm crazy, this is my first PC build, but all 6 slots I have are PCIe and EPS connectors

I have a Lian Li 011D case with a 1080 Ti card. The cables hit the side window no matter how hard they were bent. The cables moved to the top of the card, leaving almost an inch of space to the glass. I will use them in all my builds.

I almost got a star for not having two packs with a specific orientation that are just separate pieces. They do their job well. I had to order two packs to achieve what is pictured and now I have two absolutely useless reverse direction adapters.

They work well. I had to buy them in 6 and 8 pin configuration as my GPU requires it. This allowed me to reroute my PCIE power cables so I didn't have to plug both cables into my GPU's power connectors. No power or stability issues, which is what I was looking for, but so far so good.

Incomprehensible layout. Most of my packages definitely have the wrong female end glued to them (4/6 adapters came with the wrong female end). I bought a set of 3 for the RTX 3080. Of these 3 type A only one fits on the 6+2 pin cable. Others don't. Not sure if they changed this mid production but it renders them unusable with my PSU (Corsair Rmx 850). waste of money.

I originally bought this because my glass pane wouldn't open due to protruding extension cords. I saw and bought them at Revain. When they arrived and I put them on my computer, not only did it solve the glass problem, but it was very aesthetically pleasing. I am very happy with them. The only issue I would have with them is that they are a bit pricey for what you get. $7 for two rectangular adapters. If like me you have an RTX 3080 you will need to buy two packs of these as this card requires…

These adapters work seamlessly on my RTX 2070 Super; However, they are a bit more schematic than I would like. The foam on the back of each adapter does not appear to be securely attached. I don't think the foam will fall off once the adapters are installed in the computer, but I would be concerned about storing them loose in a box that can rattle. The PCBA marking is slightly different for the two packs. All four circuit boards are marked PH38 REV1.3 9K13. 1 of 4 is marked LARGE 1952, 1 of 4…

Woohoo. Works very well. Didn't short out or burn down my house so it's a win. Again, I don't overclock. It's flusher (and cleaner looking) than those low-profile connectors. The "kit" comes with a top and bottom corner connector. This is not a product or manufacturing defect. So for a card like mine (Zotac 1070 Amp!) I need two kits (e.g. ordering 2). It also means I have two connectors in the wrong orientation in my box. I need to investigate further, but my cheap multimeter shows that some…