🔌 Cat5e Ethernet RJ-45 Keystone Jack Cat5 Punch-Down Network White - Pack of 20 Review

The connectors on this connector are angled diagonally. The good news is that you can install them using the included plastic caps that double as snap-on caps. The bad news is that if you already have a hammer drill you can't use this one and will have to cut off the ends of the wire separately with flat bottom wire cutters. Clearance above (or below depending on how you turn). Almost all keystone jacks have some of these, but these look worse than average. In addition, they are easy to install

I used a non-punch punching tool and had no problems with it. The angled lugs made them easier and quicker to install than a traditional angled connector. I had a small job - only 6 sockets, but all 6 worked fine the first time. I've had some connectors that spring back into the trapezoidal panel when the cable is plugged in, although it's incredibly difficult to get into the trapezoidal panel during installation. It was the opposite of that - I've paired them with Leviton plates and they snap…

I bought them in a pack of 5. The detail everyone cares about: the color coding is very helpful as I don't slam as often as I used to. This product was easy to work with. I think I've used all but one and had no problems. Highly recommend, especially for beginners or people like me who have done something like this before but haven't done it in a long time. Super easy to punch; fits perfectly in my empty keystone rack. Definitely recommend!