🔌 CURT 55502 Custom 4-Pin Trailer Wiring Harness for Honda Accord & Acura TSX, Vehicle-Side Installation - Black Review

Wrongly determined what is suitable for Acura TSX station wagon, did not work at all and spent an hour of my time disassembling and reassembling the trunk lining. Disappointed although build quality seems ok why advertise as part of PnP when it isn't.

Installed this kit on a 2005 Honda Accord LX and it was very easy. Remove the driver's side cover (felt) by gently pulling it away from the clips with your hand, then simply disconnect the wires going to the tail light and connect to the wire harness and then to the headlights. Read the instructions if necessary, but it's sooo easy. Also note that the included screw is self-tapping so you don't need a drill, just a decent screwdriver.

Acura 2012 how to install. Reconnect all connectors to the driver's side taillight except the connector with the cut dark green wire. The wiring harness comes out of the driver's taillight and goes to the passenger's taillight. Disconnect the wire harness 1 foot from the driver's side tail light, pull the dark green wire out of the split plastic cover. Connect the green wire here and you're done. Wrap the connection with tape and reinsert the wire into the tube. 10 minutes to remove panel…

Original device. The 55502 model is a perfect match for a 2005 Accord. As others have pointed out, instructions are useless. However, you don't necessarily need them. You don't have to worry about cable colors either. In my setup, each connector only fit one way, so it wasn't difficult. Everything is installed on the driver's side. The cable does not have to be routed from the passenger side. I added a twist: Between the faucet and Kurt's controller, I screwed in the wire that controls the…

The product is said to fit the 2013 Acura TSX, but my 2013 TSX does not have a green wire connector for the right brake light, so my right brake light does not work after installation. There is a post on the Curt website that someone found the same issue on a 2012 TSX. Called Curt support to discuss this and said it was an Acura production difference, not a Curt issue. I asked them to send a 3 pin plug to fix the problem, they refused and told me I could go to a commercial trailer wiring…

I'd easily give it 5 stars if it was just plug and play like Kurt and Revane suggested, but it didn't work for a 2008 Accord coupe with V6 and 6 speed manual. . I had to take a lone green wire connector from the trailer harness and connect it to the right hand brake and turn signal wiring. For me it was a clean and easy install, but for people who don't know how to do things like this properly, this wiring harness isn't going to work. You will NOT find a turnkey solution for this SPECIFIC…