Header banner
Revain logoHome Page
πŸ’» cy mini usb to usb cable: high-speed 5pin usb-a to mini usb-b data cable with up angled connector logo

πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
πŸ”Œ Wiring & Connecting, πŸ’‘ Industrial Electrical

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector
img 2 attached to πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector
img 3 attached to πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector
img 4 attached to πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector

Description of πŸ’» CY Mini USB to USB Cable: High-Speed 5Pin USB-A to Mini USB-B Data Cable with Up Angled Connector

USB 2.0 A Male - Up Angled USB Mini B Male cable 50cm. The USB mini B 5pin type male is angled 90 degree type. with braid cable.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 5 out of 5

Great for hard-to-reach places

With this cable I installed a non-original navigation system in the car and I am very happy with it. Its design hides the cable.

Pros
  • Satisfied
Cons
  • Will write later

Revainrating 1 out of 5

Conector enganoso :(

no le quedaba bien a mi gps garmin, el anuncio decia que era compatible, pero al momento de conectarlo no llegaba la alimentacion al gps. no puedo recomendarlo al menos: no para gps

Pros
  • Dope πŸ”₯
Cons
  • Dear

Revainrating 1 out of 5

Bad quality: bad connection

I used this to connect my Raspberry Pi 4 to my Creality Ender 5 Plus 3D printer. Bad motion, every time I turned on the heater to the bed or nozzle, the octoprint timeout stopped the print job after about a minute. I ordered some ferrite beads and placed them next to the connector on the side of the printer. Then the RP4 connector. Both. No changes. This cable is in a bunch of old useless cables.

Pros
  • Lots of positive vibes
Cons
  • No power