DayMark Resistant Stainless Steel Metal Review

Dimensions vary widely. I have big hands, I ordered a medium size because I wanted a good fit. The glove sent was marked "medium" but it was VERY large. Sent back for a smaller glove hoping it would fit.

That's the problem, the sharp ends, even on large knives, go into the holes and leave a pin prick. Was hoping to avoid this but prevents seams on big misses. Just don't expect there to be minor minus wounds. I wish the post was better but adequate. By the way. [tat] wouldn't stop banging a hammer :)

Sizing is clearly not the same, these are a full size larger. Or should I say two sizes too big because the metal gloves we use for cutting in sewing are already big. That means if you have a big hand, buy a medium one. However, with this brand you will need a small one. A few other things. Usually when you buy a glove you get a plastic holder that fits over the glove. it rides between the spaces between your fingers. This is to ensure the glove stays on and serves as an adjustment if the glove