🚦 DNA Motoring 3D LED Bar Third Tail Brake/Cargo Light Chrome/Clear [07-18 Tundra] Review

Very cheaply made, ordered in September, finally time to install. Everything was going fine until I tried tightening the nuts. The whole bolt and nut started turning. He removed the points of light where the light doesn't sit, there's no way to pull it up. I will update the review when I get another light asap

Bought for my 2011 Toyota Tundra and when my truck went through the car wash for the first time a week after installation I got moisture/condensation in the case. It does not sit flush at the top and bottom and has a gap of approximately 1/16 inch. Not sure why the upper lip was only with part of the 3M tape. I wouldn't recommend this to anyone.

Everything ok except the screws broke when pressed! Be careful when buying, the installation is not easy, especially with the screws that break easily. I had to use glue! And I had to go to the hardware store to buy nuts for the bolts because they don't come with the kit. Very disappointed but I can no longer remove and reconfigure it, that's how I installed it. Until he loses I guess. my lost. Do not buy this product.

To install this brake light you will need to remove the headliner from the truck to access the installation hardware. Based on some reviews and blogs I read about this fixture after it leaked, so putting silicone around the 'seal' is highly recommended. The light itself looks pretty cool. But once you know what it takes to install it, it's not worth it. This is a straight screw that you can replace with your factory one, not to be confused with modifying or altering the factory light. Hope this

Very very cheaply made, ordered in September, finally time to install. Everything was going fine until I tried tightening the nuts. The whole bolt and nut started turning. He removed the points of light where the light doesn't sit, there's no way to pull it up. I will update the review when I get another light asap

Bought for my 2011 Toyota Tundra and put it through a car wash for the first time a week after fitting, moisture/condensation formed inside the case. It does not sit flush at the top and bottom and has a gap of approximately 1/16 inch. Not sure why the upper lip was only with part of the 3M tape. I wouldn't recommend this to anyone.

Everything is fine, except that the screws broke when pressing! Be careful when buying, the installation is not easy, especially with the screws that break easily. I had to use glue! And I had to go to the hardware store to buy nuts for the bolts because they don't come with the kit. Very disappointed but I can no longer remove and reconfigure it, that's how I installed it. Until he loses I guess. my lost. Do not buy this product.

To install this stop light you will need to remove the headliner from the truck to access the mounting hardware. Based on some reviews and blogs I read about this fixture after it leaked, so putting silicone around the 'seal' is highly recommended. The light itself looks pretty cool. But once you know what it takes to install it, it's not worth it. This is a straight screw that you can replace with your factory one, not to be confused with modifying or altering the factory light. Hope this is…