Easycargo M.2 Heatsink Kit, Cooling Heat Sink + Thermal Pad for PS5 M.2 NVME SSD 2280 (70mm x 20mm x 3mm), Copper 1-Pack Review

I've been using my new nvme for a few days and found that it sometimes reached up to 65 degrees Celsius but worked under 50 when idling. Thinking it was a cheap enough experiment I ordered this one heatsink kit and immediately saw that the temp is around 40 when idling and now rarely goes above 50. Another plus is that the temperature doesn't fluctuate much, with slower and lesser rises and falls. Although the photos show a heatsink, it is actually a 2 pack as shown in the listing. I had no…

I bought this solid copper heatsink to install on my WD_ BLACK SN850 M.2 NVMe SSD which I put in my PS5 and it works great, many heatsinks went out of stock – for all buyers them for ps5 and this one fits sony specs easily. It's a heavy little solid piece of copper and copper works better than aluminum so far so good no problem seems to work great PS5, with just a skid plate works great and is solid copper of course we'll always stick with it, highly recommend for PlayStation 5 M.2 SSD slot.

I bought this one piece copper heatsink to install on my WD_ BLACK SN850 M.2 NVMe SSD that I put in my PS5 and it works great, many heatsinks started to close disappear because for everyone who buys these for PS5 and this one easily fits the Sony specs. It's a heavy little solid piece of copper and copper so far works best as aluminum , with a skid plate on just one works great and is solid copper obviously we'll always stick with it highly recommend for a PlayStation 5 M .2 SSD slot.

This copper heatsink is well made. The hot melt adhesive strip is slightly larger than a copper heatsink but can easily be cut off by placing it on top of the heatsink and gently pressing on the edge of the heatsink and wiping off the excess. Unfortunately this heatsink combined with the supplied hot melt adhesive is too thick for my Dell 9370 laptop resulting in the bottom of my case not fitting and causing it to bend and protrude. When I didn't add hot melt glue, the bottom of the case seemed

I've been using my new nvme for a few days and have noticed that it gets up to 65 degrees Celsius at times, but when idling it worked in the low 50s. Enough experimenting, I ordered this heatsink kit and immediately saw that the idle temp is around 40 and now rarely goes above 50. Another plus is that the temperature doesn't fluctuate much, with slower and lesser rises and falls. a heatsink, it's actually 2-pack as listed. I had no trouble tightening the rubber straps and they seem flexible…