Enhance Performance with GY6 125cc 150cc ATV 🔧 Quad GO Kart Wiring Harness Loom Kit CDI Magneto Stator Review

Unbeatable price but straps broke in 2 places. The plugs, which clearly went in some places, were smaller! I still have no spark so I haven't solved my problem! But I think that's all you need for that. This is a good starting point to narrow it down to one or two parts.

An internal short circuit was detected when the belt was received. I cut it and hand made my own harness following the diagram and now I have a spark. Good: All electrical parts worked. You get lots of color coded wires to use to create your own wiring harness. Ignition. The wiring harness that was sent to me was faulty.

Worked on my yerf dog cart. There are no instructions so you must know what you are doing. This strap fits the scooter but I removed the loom and put it in the carriage and then replaced the loom. As this was for a scooter there are extra connections but this allows for more lights to be connected! I had to use smaller connectors for the coil, but that's a minor thing.

The suspension itself was intact but the binding is right at the connection points or wrong at three of them and I'm still trying to figure out and establish what connections do what you think they need to do to have. The ends are labeled or what each wire harness does. A breakdown of what each link does and what goes with it would make it a lot easier considering I ordered it as a spare but there was none on the engine I applied to

Item as described and delivery was fast. This is perfect for my Kasea 150IIR. I have a 150cc engine that I replaced and it was a breeze to put together. All of these cables have already been color coded. My 7 year old even told me which ones went to which ones. Great job they have done with this kit. I really think that if I have another bad wiring problem I'll just replace it with this kit. I need more time to find shorts that can easily wear this.

Schematic not shown unless you have the exact model it was made for (which is not listed), you will need some electrical knowledge to install. The CDI connectors are different from the stock CDIs I had. The ball connectors on the stator are rubbish, even when tightened they aren't crimped - they turned them into decent scoops. No shutdown/working, only keys. Hand carburetor lever - maybe connected to electricity? No charts = who knows!