Etmact Fingerboards: Professional Finger Skateboard for Enhanced Performance Review

Very impressed with this board. The only complaint is that the padding they offer is too thick. A thin strip of rubber would be much better. Also, the trucks make the board quite high and it's much harder to pop on than on a technical deck.

This is not a very good neck for beginners or professionals. I strongly recommend not buying this product as it is not worth it. This product probably costs about 5 cents! Very bad. Two minutes after installation it broke! It also took an hour to assemble as the carts barely fit on the board. Terrible product.

Not bad I think. My 6 year old loves it. I had to assemble it for him and it was kind of a pain. The screws that go through the board and into the carriages have to be cut into the carriages themselves, so the small screwdriver that comes with the kit requires a lot of force. For this reason I won't buy any more.

This should already be installed. The holes in the metal were too small to tighten the very small screws. I had to use a small 1/16 drill to open up the holes or the small screws would pop out. I'm sure no two boards are alike considering how cheaply they are all made. I bought this for my grandson. I don't get another.

The holes on the board are off center so the wheel sticks out on one side. The holes don't line up with the trucks either. Trucks are not threaded so it is very difficult to screw them on. The trucks are also not properly spaced on the wheelbase (too far from the tip of the tail and nose), causing the board to lack "pop". Wheels keep falling off. Hands down the worst bar I have ever seen and a disappointed child to boot. I'd rather buy a tech deck than this junk. Waste of time, effort and…