Enhance Your Motorcycle's Taillight with EverBrightt 2-Pack Red + Yellow 3528 + 3014 48SMD LED Light Strip Review

The wires for this are tiny but relatively insignificant. The quality of the LEDs seems to be poor as I had two bad spots straight out of the box. At least it comes with two.

Both headlights worked great and matched my rear fender perfectly. Adhesion seems fine, but time will tell. Bright enough and you can always add a second one if needed.

Very bright I have 4 of these installed on my bike. 2 behind the body and 1 on each side. Wire so both yellows work with the left signal and the right signal. Wired rear brake lights only. The only criticism is that the cables are very thin. I soldered them in a thicker wire.

Not worth the $10.99 I paid. Not even remotely waterproof. I wouldn't even splash them with water. The housing around the wire slides right out of the end of the light and the light strip slides into the plastic housing. The best thing about this flashlight is the 3M band and that says it all.

I use one lane for left turns and another for my right turn signal. Bright enough for my little scooter. sticky backing that I put on my pizza delivery bag on my scooter and hasn't come off in a month. I put mine in a plug so I can easily replace them if I want to change them or replace if they burn out.

Have a few of these on my off road mini bikes. As mentioned, the wires on it are very thin and short, but I was able to solder on larger wires. One came with two LEDs as seen in fig. I didn't notice until I already inserted it. They're not very bright in daylight, but they're a subtle and inexpensive addition. Used them for about 6 months without any other problems. If I had to do it again, I would probably choose something different.

I bought these to use on my saddlebags as extra headlights as my new turn signals don't have built in running lights. I really like her. I connected the left and right turn signals to the same turn signal and I think it works fine! The light is bright enough and the brake light competes with the built-in brake light. The wire is shorter than I would like so I had to lengthen it. I think if I used it at the rear as a traditional stop/go/turn signal it would be barely long enough to reach…