G.Skill RipJaws Series 64GB (2 x 32GB) 260-Pin SO-DIMM PC4-25600 DDR4 3200 CL22-22-22-52 1.20V Dual Channel Memory - F4-3200C22D-64GRS Review

Purchased for AsRock Box 4x4 4800U, had some reservations as it is not listed as compatible. Worked beautifully - ran memtest86 for 24 hours - no errors. and also. I will definitely buy G.Skill again for my future projects.

For those interested, this RAM plugs into the 2020 Razer Blade Advanced 15" Advanced, it will boot up and start working right away with no hassle something needs to change the BIOS, although it runs at a slightly slower speed than it is possible without updating the BIO and firmware to enable XMP (I've never figured out how to do that and if it's possible). This is a big upgrade from the standard 16GB.

Simply use two fingers to gently press the tabs in opposite directions to release the installed RAM by sliding it sideways. All you have to do is insert the new RIPJAWS 3200MHz RAM. 1 module at a time into the LTK8 RAM socket, hold your index finger and thumb on the corners so you can insert both sides into the bottom of the socket, then gently guide it down until it's on each side of the RAM module snaps into place. Do this for each G.Skill DDR4 RAM module you will be installing. Do this in a…

Purchased for AsRock Box 4x4 4800U, had some reservations as it is not listed as compatible. Worked beautifully - ran memtest86 in 24 hours - no errors. Pretty fast for laptop memory. Will definitely buy G.Skill again for my future projects.

Tested on the following devices1. NUC7 - works, but RAM feels very warm with no load - removed and no longer used.2. NUC8 - Works normally and works without load.3. Thinkpad P52 - works great and works without load. FYI, just because it works doesn't mean it's compatible, recommended, or stable. Will be updated if there are problems. The seller / Revain also delivered very quickly.

Simply use two fingers to gently press the tabs in opposite directions to release the installed stem, slide to the side and all you need to do . Then insert the new RIPJAWS 3200MHz RAM module into the LTK8 RAM slot one at a time, placing your index finger and thumb on the corners so both sides can be inserted into the bottom of the slot, and then gently guide it down until it clicks into place. in the right place on each side of the RAM module. Do this for each G.Skill DDR4 RAM module you will…