Gurlleu 4500psi Paintball Filling Hose Whip Extension: Stainless Steel Air Fill Station & Charging System - Ultimate Performance for High-Pressure Paintball Air Refills Review

A good addition to the PCP air compressor kit. With connectors and connectors already installed, you can create any combination of built-in filters. The stainless steel reinforced hose wants the best and doesn't pinch like coil springs.

I have a 5lb CO2 tank hooked up to my Soda Stream. I needed a hose that could withstand high pressure and that was just the ticket. I've now connected it (with other connectors that you buy separately) and it works great.

This extension is definitely well built. It's added to the pumps (assuming you're using a hand pump) to increase the pressure, but I like that it allows for some flexibility in filling your PCP.

Wanted to like this hose but unfortunately it leaks. There was a pinch between the severed side and the hose. Did a bladder test to confirm the problem. returned it I bought a scuba adapter so I don't have to pump by hand anymore.

I received this for my Umarex ReadyAir PCP compressor. I wanted something that I can filter in-line during the wet summer months to prevent condensation from forming. This extension hose is perfect. It also allows me to raise the airgun higher to avoid getting water inside. Very happy with it!

I bought this hose to use as a leash for my paintball gas station. I've been using it to fill paintball tanks off my scuba for the past four months. My tank is only rated for 3500psi and normally only 2000-3000psi goes through the hose so I know I have never over pressurized it. Everything worked fine for the first few months, but now the hose is leaking from the seam between the braided hose and the fitting. I do not recommend it to anyone.

Shaft leaking air through entire braided hose section. In the video, the pressure is only 3,000 psi. The maximum pressure the hose has ever seen was 4350 psi. Test yours as soon as you get it by plugging the end, squeezing the hose and submerging the whole thing in water. I couldn't understand why I couldn't fill my tank above 200 bar. /3000psi. It took me a very long time to realize that the problem with my system was a leak from the braided portion of this hose. I couldn't hear the leak…