🚀 Ultimate Off-Road Adventures with High-Definition Center: Polaris Kawasaki Review

Great product and very easy to fit! I recently ordered this mirror for my 2017 RZR 900 S and it arrived on time and was very easy to install. I didn't have to disassemble half of my RZR to reattach the brackets. The whole installation took only five minutes, it was very easy to set up and it works great. I mounted a spare tire on a rack just above my RZR and this mirror makes it easy to look around. High quality aluminum brackets attached with Allen screws that keep it perfectly in place. I…

Very happy with this mirror. I installed it on a 2019 RZR S4 1000 with a Ferreus Industries roof and it fit perfectly. I installed the brackets horizontally or facing straight back. It's nice and fits snugly on the roof and doesn't block my view. I was sitting right above the driver's seat. I wasn't sure how it would be positioned after looking at the photos but once installed it fits perfectly. Assembly tip: There were enough screws, it was enough to tighten one screw 2 or 3 turns, then start…

Brackets are durable aluminum and screws are stainless steel. The mirror appears to be of good quality. The brackets aren't quite round, so there's a slight gap between them and the 1 3/4" cross member. The screws aren't long enough to properly close that gap. They drilled and cut the staples through and through. , that wouldn't be a problem as the longer screw could have squeezed both halves of the mount together, but instead the longer screw just pushes the bottom out Ten minutes of work…

I will start by saying that everything in the description is true and I will highlight some of the features that I like and some of the features that could be improved. I bought this for my 2017 Polaris rzr 900s - love how easy it was to install, it's as easy as unscrewing the plates than installing (you may have to remove the roof or windshield to install) – I also like it very easy to clean. I use dish soap and water and that usually helps. It is not very easy to scratch. Some things could be

Great all round product for the money. It was installed on a 2020 Honda Pioneer 1000. According to the product description, it fits. The brackets are machined from high quality aluminum and installation was very easy until the brackets got too small and completely encased the roll cage top tube. To do this, I had to bend both sides of the bracket slightly wider to accommodate the roll cage. It wasn't too bad, but the company only included a length of screws that were a bit small to easily…