🚗 Upgrade Your Car with HX-CQHY 921 Led Car Bulbs Canbus No Error T15 Led Bulbs W16W 906 Led 912 Bulbs - Bright 15-smd 3030 Chip T15 Led Car Bulbs for Backup Reverse Light (4PCS/pack) Review

Update: 6 months later and all failed. A replacement brand must be found. Original Review: I use this for my bedside lamps and third brake light in a 2020 RAM 1500 Longhorn. Every headlight on the truck, inside and out, is LED except for two night lights and a third brake light and I have no idea why they did that but it was driving me nuts. These lamps were the solution. They work great, look a lot better and don't interfere with the transponder opening/locking doors and starting the truck…

I used it on my 2010 Tundra. They work great. I just unplugged the old lightbulbs and plugged in these little ones. Nice and bright, but not obscenely bright. You get a little warm. Not as hot as incandescent bulbs, but still pretty hot. Oh, here's an old tip for hard-to-remove lightbulbs - duct tape. Allow the bulb to cool, wrap the bulb with a small strip of electrical tape. Leave a slightly curved section for something to grab onto and just pull it out. ***Update*** After 5 months of use…

Update: I have noticed that while these bulbs are listed as fault free, they are not. Used as reversing lights in my German car, they flickered. Now two of the four in the set have already failed when used in my truck's body lights. I replaced the truck body lights on my pickup truck because the first set of LED bulbs I used failed very early. I chose a different brand. They are bright and are working very well so far. Since I only needed two bulbs, I found that the other two would fit in one…

I used them on a 2016 F150 pickup tail light. I understand that this light is frequently switched on and off and can be prone to heavy unintentional use. That being said, I was expecting a year at most for such cheap LED bulbs. After about 6 months the right bulb started flickering so I replaced it with a spare bulb. I switched the center brake light to red this afternoon because the red lens tail light was too orange for my liking. That's when I noticed that the left light bulb was already…

I installed these on the car by replacing the factory 921 bulbs in some of the factory accessory lights. I used to install LEDs from other brands for the same purpose, but these new bulbs were significantly brighter than even those that were brighter than incandescent but started to flicker or burn out, probably due to cracked solder. So they are really very bright for this type of lamp. Unfortunately, in less than 3 months, one of them flickers. Again, I suspect the solder joint broke due to…