🚗 Enhance Your Toyota Camry's Style and Safety with iJDMTOY High Power LED Daytime Running Lights/Turn Signal Lights Kit Review

They work as promised and as shown. This is a very easy setup if you're raising the front of the car so you can crawl under it using ramps or jacks. Then you remove the two pallets with a 10mm nut and simply pull out the spacer pins. Then you have free access to the entire enchilada so you don't have to just plug it in and secure the wires with the included zip ties. Just be careful when routing the wire as the sharp corners of the frame can short out the voltage wire (it comes with a fuse…

Good article, but some installation changes will improve your experience. For this kit to work, you need to do more than just hook it up. included) directly to the ACC feed. This means your new headlights now only turn on when you start your car, rather than with a switch on your steering column. Instead, I connected the wire to the parking lights. The black wire on the parking light is a plus. It is located next to the projector lamps and contains a small yellow 194/168 bulb. Now my new…

I've been using these for a few weeks now and they look and work well. Installation wasn't terrible but I would definitely recommend just removing the lower plastic guard and approaching it from below (you have to jack the car up or of course lol) especially for the passenger side as the washer fluid reservoir is a Art is otherwise on the way. I also recently routed the wire that powers the white LED part to the headlight relay (just below the one you're supposed to be using) because I…

The fit was snug with the included washer ensuring they stay in place. There's enough light output to illuminate the ground in pitch black darkness, as good as the stock fog lights I suppose. Amber is real amber, white is somewhere between 6000k, 6300k, it has a slight blue cast. It's not perfectly white xenon, but it's just what I need to match my low beams. The only thing that didn't quite convince me was the installation. Pulling the wire through the hole in the relay's fuse contact was…

Installed on a 2017 Camry SE. The ventral shell has been removed to allow better access to the cartridge. There wasn't a suitable metal place to mount the resistor, so I threaded the wire through the resistors and threaded it through a couple of nearby holes, leaving the resistor dangling freely. Secure the remaining wires with cable ties. Just to make sure the connecting wire didn't come loose, I wrapped the wire connections with tape. I checked everything before replacing the pan…

Ordered these to add to a 2016 Toyota Camry Special Edition. Received in 2 days, excellent delivery as always! Installation went well, for me, as per some previous reviews, it was easier for me to get out from under the car by removing 3 screws from the skid plate on either side and installing the new LED lights as instructed. There isn't much metal area to attach the resistor to, so I added some zip ties and was able to attach it so that it didn't touch the metal and plastic in the bay, making

Save money. This product looks very valuable from the outside. You get white daytime running lights and a yellow LED for the turn signal. They're relatively easy to install with a few YouTube video tutorials. I installed them myself so it was quite a lengthy process but it only took me about an hour. The product was bright and did exactly what was explained. However, the durability of the product is where it falls short. My right yellow turn signal bulb blew out after 4 months. The white…

Wasn't too bad to put in my car. If you don't have a dedicated place to put your resistors, you may need to mount them so they don't touch anything with plastic (you can get zip ties for that). The brightness is normal, it could be better, but it does the job. Can't say much about durability since I just installed it today, but I'll update if anything happens. It took me about 30 minutes to install. I recommend to anyone who wants a white light. In addition, there were no hyper blinkers before.

Installed same night I received it, no problems with installation. The instructions were very clear. a bit awkward with my car as I didn't remove any plastic in the wheel arches or bumper. I just loosened a few screws and lifted the plastic a bit to get my hands in. The bulbs have a rubber grommet instead of a twist lock, but after a few minutes of wiggling and pushing in, they fit! First picture, this is what the factory "amber" bulb for daytime running lights / headlights looks like on. The…