📺 Monoprice Cornerstone Series Full-Motion Articulating TV Mount: 37in to 63in, 132lbs Max Weight - Black Review

Great corner mount, especially for $60. Installation was a little tricky and I replaced the smaller 1/2" screws that come standard on other full size TV mounts. It's really durable and easy to adjust. The LG TV is 50 inches and fits well in the corner. I am very happy with the mount!

Mount 60" with this corner bracket. Remember that it is designed for concrete or brick walls! Installation instructions do not explain use for regular drywall. Viewfinder and riveted but it was slightly off center on the mounting brackets but you couldn't see it when the TV was on mute. Overall I'm very happy with it and it comes pre-assembled for easy setup.

I used this mount for my Insignia 43 inch Smart TV. Certainly not the most stressful weight test, but the mount is very well made and I'm not worried that it will also withstand an earthquake (West Coast here). Others have mentioned the inaccuracy of the built-in level, and while it's not perfect, it gets you close enough to then tilt a few degrees and fine-tune with the real level. adjustments. Friends commented on how strong the rails and mounting brackets are. You will not be disappointed…

High quality mount and works great. However, the wall anchors that come with it are rubbish. You are not working. The ones that came with mine ended up not being shared. So if you don't find out before you bang them against the wall, you're out of luck. I had to pull them all out and cut the ends where they were still together during production. Even after I did this and put them back into the wall, they didn't stretch or stick. I had to go to the hardware store to buy all the new anchors. This

I was surprised that this mount fits a 65 inch TV. It is not recommended to hang the TV above the chimney (the installers will not install above the chimney). 2 reasons, #1 not being able to use your fireplace, #2 the recommended viewing height is 3-4ft from floor to bottom of TV at 10-15ft so got my mount about 5ft off the ground Installed . So I needed a strong corner mount and this is perfect. However, the range of motion is limited when installing a 65-inch TV, but tilting the TV is enough…

This has to be set so that the scale on the front of the device shows the scale. This means the brackets may need to be installed "out of plane". The instructions are useless and contain no text, only pictures. The block is so big that I decided to make a bracket template and drill holes before installing it. The brackets were perfectly level, but the front of the unit where the TV is mounted is uneven. I contacted the manufacturer through Revain and their response was pathetic. They said to…

Just by looking at the design you can tell that it will not be easy to install while maintaining a flat and flat surface. That. But it's also very valuable for those corner setups on a budget and helps a lot when you create a template, have a laser level and plan out each step of the setup. One important thing to note: the included anchors are for concrete only, not drywall. Where I could only attach to drywall, I've used my own snap-in tumblers rated at 265 pounds, and where I've encountered…

I am satisfied with this corner TV wall mount, but with a few exceptions! First, the built-in spirit level that comes with this mount is a far cry! DO NOT BELIEVE IT! Get a professional contractor level! 2.) The bracket is designed to drill more holes in the wall plate than wall studs. I drilled a third hole in each bracket so 3 screws would go into the wall studs on each side. (The included wall wedges are completely useless!) I wouldn't trust them to hold much weight at all! I also didn't…

Instructions were rubbish. There are too many screws and mounting options without words to point you in the right direction. I find the product too heavy to hold and write on at the same time. Required as a paper assembly template. Need better insoles. The screw continues through the side and not through the tip for it to work (inserts still didn't work properly). Nothing was straight or even. I had to bend the part that the TV attaches to to make it level and the brackets that attach to the…