MyLifeUNIT Hair Dryer Holder Wall Mount: Efficient Aluminum Hair Tool Organizer with 2 Cups Review

Installation instructions are not included but fairly easy to install. Drywall anchors were incredibly brittle and would not withstand being driven into a pre-drilled hole. With one of the three anchors, I managed to bend the other two aside with a light hammer blow. I ended up using some of the spares I have that hold up better. Looks good and with three lag screws it feels like it's solid to the wall. However, I'm a bit skeptical about how well it will hold up with my hair dryer. Angle tilts…

I bought this as a metal holder because I didn't want to store my heat styling tools in a wooden holder. Upon arrival, all items have been placed securely in padded bags to ensure each item does not get scratched or scraped during transit. Drywall screws and anchors that fit into the small holes already made on the metal shelf. The hairdryer section rotates, which is a nice feature since ours is on the sidewalk and I can move it around so it's out of the way when I'm done. The metal cups can be

I ordered this for my husband's bathroom. He just needed something simple to hold the hair dryer and a few other small items. When I opened the box I thought it looked really cute and would go well with his decor. I felt it was a bit cheap and it was a lot easier than I expected to hold a full size hair dryer. After trying to mount it on the wall for an hour and finally throwing it away with 3 medium sized holes in the wall. We ended up lifting it up there, but I seriously don't think it would…

Very nice. Exactly what the woman needs. Maybe a little heavier (I would pay for that). She has a standard hair dryer and the shelf flexes a bit when getting in and out, but it doesn't bother. I want to say that you guys should take left and right stances. I would buy another one for the other side but with the way it's made now as you can see it wouldn't look very good. Some people may want the dryer to be on the left instead of the right. A slightly heavier sensor would also be nice. Your…

I like the concept, but the manufacturer saved a lot on this product. Worst of all, I had to sand down any sharp edges left over from the manufacturing process. There were still burrs on EVERY edge from the dies and shears used to make the part. The last thing you want is to cut your fingers or hand on the sharp edges when reaching for something on this shelf/holder. There were also plastic rings in large holes. They didn't fit properly due to all the flash from the casting process. You have…