💡 NOVSIGHT H13/9008 LED Headlight Bulbs - 12000 Lumens, 300% Brighter Conversion Kits - 60W, IP68 Waterproof, 6500K Cool White - Fast Cooling Halogen Replacement Review

Purchased for Ford Freestyle 2007 I replaced the headlights and it was as easy as removing the old bulbs and putting in new ones. It was just plug and play. I've read that other models may not have enough power for daytime use. They work for me in all modes. They are also very white and light.

Installed in H3 Hummer. Installation on the driver's side was straightforward, the LED was timed correctly and after removing the fuse box cover, installation was easy. The passenger side is more difficult to access and the LED has been moved almost 180 degrees out of the box. It took some practice landings and collar movements to get 3 and 9 with the fan raised. Significantly brighter than the almost useless factory lights, but haven't had a chance to try them at night yet. I don't see any…

I bought these for my girlfriend's Jeep Patriot and they connected perfectly, she called me a day later and said the lights flicker on and off while she drives what is Dangerously dangerous when you drive in the middle of the night and can't see anything in your flickering lights. I won't be buying from this car again should you be able to rely on it should work and not flicker. This is the best way to get stopped.

Check out the F150 installation video. three 10mm screws for the headlight housing. Perfect OEM fit. Be sure to remove the hex screw in the LED light housing, install the flashlight and retaining ring by rotating only the plastic retaining ring, not the LED fan housing! Once the ring is in place, rotate the LED fan housing until the light panel is vertical and the non-numeric LED panel label is on top. Do this on both sides of the truck. If you see your treble/bass are reversed, you need to…

Installation Tip: The OEM bulbs had a rubber o-ring that detached from the bulb and stayed in my Mustang's lens holder. Because of this, the new lightbulb seemed unsuitable. After figuring out what happened and pulling the rubber out, the new bulbs fit in with no problem. The picture shows the original bulb on the driver's side and the new LED on the passenger's side. You can see how much brighter and whiter the LED bulbs are. Time will tell how long this little fan lasts when subjected to all…

Installed in just 2 weeks and one has already stopped working. The headlights work 6 hours and my truck does NOT have daytime running lights. Updated 08/05/2021. I installed different LED bulbs and encountered the same problem. It turns out that a pin in the socket on the side of the truck has fallen off due to age. It was not easy to trace the problem. So I replace the socket on the truck wiring harness. Will be updated after replacement. Updated 08/11/2021. Both cartridges in the headlights…

Good headlights, good street lighting. I recommend adjusting the angle so the thin edge is vertical when attaching to the car. This seems to work well and keeps the light off other drivers' faces on my Mustang anyway (Note: I don't use set screws, they aren't needed to mount the light so the angle can be easily adjusted.) I had one with a set screw that didn't come out and I recommend returning the lights if that happens. because you can't adjust the angle with the adjusting screw even if it is