💡 Industrial Electrical Oversized Recessed Lighting Fixture in White Pack Review

Bought these to replace my standard 6" decorative recessed lighting ring. Unfortunately, the ring hole on this item was inexplicably too small even though it was meant to replace the 6" slip rings. In order to put it in place I had to shave the plastic around the hole. It's just not worth it.

I am fed up with old rings that have turned yellow and brittle from the heat of the light. These rings are perfect for replacing the old decorative rings on your 6" downlights. They are very easy to install, no tools just a ladder. Unscrew the lightbulb. Reach inward and release the two springs holding the decorative glass in place. Lower the pad. Replace the old ring with a new one. Attach the feathers. Reinstall the lamp. Easy easy.

I used them to hide a mistake cutting holes for the lights I bought. They were a little small in inside diameter for the flashlights I bought, but they are easily repaired with a razor. It took a few extra minutes but looked good when it was over. The only downside is that they're not quite as white as the ceiling and the fixtures they're used with, but aren't too flashy.

I thought they would work great The OD was neither too big nor too small and my headlights were a bit smaller than the original holes Unfortunately those are 1/8" to 1/4". "Inner rings too small for the disk lights I bought, which seem to be the standard size of all the options I looked at at Revain. Also, the plastic is very shiny and a little yellowish white so doesn't look clean and modern. You." would definitely need to be sprayed on at least a satin finish.