🔴 Phinlion Super Bright 3014 72-SMD BA15S 1156 1073 7506 LED Bulb - Red Brake Tail Turn Signal Light Review

I have a Jeep Wrangler with a fabric top and a tinted rear window that is difficult to see, especially at night. These LEDs are bright enough to see well. I definitely recommend these over standard incandescent bulbs.

Finally found a LED kit that matches the factory cartridge. Spent a lot of money on others but they were inferior and didn't fit the factory 92 S10/GMC Sonoma rear lamp sockets. These fit perfectly. A++++++ Thank you.

They are not 2000 lumens but 1000 each. I bought them to use as engine compartment lights with the hood open. It was probably light enough, but only barley. I wanted something brighter so I put one in the taillight of a 4 wheeler and it works great there.

They are bright but honestly the price is a bit high in my opinion. I thought there were more wins in the pack otherwise I would have bought a different item. Can't comment on longevity as it's only been a month or two. We installed them in an RV and they work well with less heat than incandescent and brighter light.

I wish there was some accountability for the descriptions that sellers put on their products. These bulbs are brighter than the 300 lumens they replaced and they produce a whiter light, but they don't even come close to 2000 lumens. He placed 2 of those 4 feet above the kitchen island. Together they produce about 1000 lumens. I have 1500 lumen bulbs and it would take 5 or more of these bulbs to match one of my 1500 bulbs. pants burn!x

I used one of these bulbs to replace a 23 watt incandescent bulb in an old but still very efficient Dazor folding arm table lamp. This bulb worked great in an old lamp. until it burned out after a month! You may not be able to survive the ten hours a day I use to light plants. I've used Phillips 23 watt high intensity incandescent bulbs in the past, but admittedly not for that long every day.

I replaced the turn signal bulbs on my 45 year old Suzuki GT750, obviously I can't use the original turn signals so they don't flash I bought one from Revain, and it works great. Now that I have all four bulbs installed I have an unexpected result. When I turn on the left or right turn signals, all four flash. Works great with old bulbs. So I looked at the schematic and saw that a lightbulb is used to indicate that the turn signals are being used. One lamp per side. I had to solder the lamp…