🔌 Pig Hog PY-M214M 1/4" Mono Jack to Dual 1/4" Mono Female Y-Cable, 6 Review

After reading other reviews condemning another brand I chose this one and am glad I did. It's a thick cable and does the job. The plugs are stuck. Feels like it will last a long time.

The cable seems to be of solid construction. I bought it to replace a similar, less expensive one that immediately had a bad connection rendering it unusable. This one works well with hard connections.

Works as it should, no problem. However, I use it a little differently than what I see in other reviews. I only have a separate clean and leading signal coming out of the A/B box so the amp never gets more than 1 signal at a time if that makes sense. I don't know how this would work if two guitars were plugged into the same input. I don't use it like that.

I'm sold out and bought these to replace the defective Hosa brand cables. The Pig Hog Y-Cable is much stronger and so far very quiet. I was hoping to find something even more powerful, but they should be fine for my use as I won't be plugging and unplugging them often if you're a traveling musician. You want to find something better.

This is my 4th or 5th time buying cables from this brand. Well made, durable, positive contact and LOW NOISE! That's something you can't get with cheaper brands. (I refrain from naming a specific brand name, but start with the letter "H"). I had to split the signal from my malletKat to feed both my home speaker system and my own monitor. You were perfect.

I record and bought these to replace the ones I had with the brand Hosa.short had .The Pig Hog Y-Cable is much stronger and so far very quiet, I was hoping to find something even more powerful but they should be fine for my use as I won't be plugging and unplugging them often, if you are a traveling musician you want to find something better.

This is the 4th or 5th time I have bought cables from this brand. Well made, durable, positive contact and LOW NOISE! That's something you can't get with cheaper brands. (I refrain from naming a specific brand name, but start with the letter "H"). I had to split the signal from my malletKat to feed both my home speaker system and my own monitor. You were perfect.

Great Product! I have two speaker cabinets and used this splitter to route the signal from the amp head to both cabinets. This product makes it possible! Note. It is perhaps worth mentioning that each speaker has an impedance of 8 ohms. Using this splitter is equivalent to connecting cabinets in parallel. It increases the impedance to 16 ohms, so the amplifier is loaded with 16 ohms. However the output of the amp is good for 4, 8 and 16 ohm output impedance so I'm good to go!