🔆 RUXIFEY LED License Plate Lights Tag Lamp Replacement: 2007-2018 JK Wrangler, 6500K White - Enhanced Visibility & Style Upgrade Review

I have a 2014 Wrangler and didn't have enough space in the case to install it. When trying to block the outlet I broke one of the wires and had to throw it away. I ordered a simple LED bulb from another company that fits the original case and it works great. I would NOT recommend this item.

Several people wrote that they had problems with the installation. I mounted one on a 2013 and 2016 Jeep JK. The 2016 model seems to accept the fork better than the 2013 model. It works on a plug and play basis, but you have to fiddle with it a bit to get the connector back into the housing. Once inside, you'll be amazed at the difference in brightness. So far, so good!

Doesn't really fit without modification, the factory connector bangs on the circuit board, I had to cut the connector but had to push it in and twist it anyway and the light unit stays loose. I think if I trim the LED sheet a bit it will fit better but the seller says I might damage the light I'll buy another one, trim it and see what happens.

I spent over an hour fixing a non-existent problem in my car's electrical system. It turned out to light up and go out at the same time. Bad circuit board or wiring inside, replaced a dozen fuses, tested it, finally went back to stock and no more problems. Maybe I just got a bad one, not sure, but it was a waste of my $10 plus fuses and time. low quality and quality control.

I love this LED light for my 2010 Jeep Wrangler 2 door. It's very bright and the instillation is so easy anyone can do it in under 30 seconds. It's actually brighter than my factory backup lights and illuminates the ground as well. I'm going to change my taillights to LED but don't know if they will be brighter but it's a great light. The instillation consists in pressing 2 clips on the old body. Then pull out the old lamp housing. Then pull the bulb out of the socket. Then connect the new LED…