Shield LG V40 ThinQ Tempered Protector Replacement Review

Much better than my last attempt at getting a LG V40 screen protector. The curved screen can cause small bubbles around the edges, but these will disappear with use. When the screen is on, you won't notice it. I tried another brand and my finger barely registered on the screen. It's not like this; it just works! I would pay attention to the edge of the screen and align it as close to the center as possible to cause the least amount of problems.

This is the ONLY V40 glass cover I could find that didn't have that black outline. If you follow the instructions, you shouldn't have any problems. Be patient with glue. This is the first safety glass that I couldn't immediately knock the bubbles out of. But the blisters disappeared overnight. The protective film does not cover the entire screen. But that's because of the curve in it. It covers the flat part, leaving a millimeter on each side.

These screen protectors are just a joke. I wiped the screen with an alcohol wipe and then used a "dust remover" to get the dust off so it stuck to my screen and peeled off like a cheap paper sticker leaving a sticky residue of white paper which I then peel off and had to use another alcohol swab to apply the protective film and horrible air bubbles on both sides. After rejecting air bubbles, I turned on the screen and saw that the screen protector on the bottom was badly scratched on the…

This screen protector is fantastic! Installation is of course the industry standard -- remove the old screen protector (if you still have it) -- wipe, wipe, wipe the screen -- use dust removal tape -- inspect the screen for dirt/dust -- put on the mask and use the dust tape to peel off again -- carefully expose the "sticky" side of the protective film and slowly lower it onto the screen -- done! The kit recommends using the "tape loop" method for alignment and installation, but since I have a…

Fantastic value for money. All other protectors for LG v40 just came off after a while or broke very easily. Despite using it with an otter. They all got dusty underneath for a few days too. This protection really sticks to the phone. Just make sure you watch the short video and follow the instructions carefully, or you'll end up with a blister on the edge that will never go away. I made that mistake on the first defender. Luckily there was more than one. I often drop my cell phone. It wasn't…

it's a bit big for the curved glass parts of the phone so the sides protrude a bit but other than that it stuck even to my slightly scratched and cracked screen with no bubbles that Installation wasn't the most intuitive, and I ended up just lining it up with sight rather than using tape, which still worked well in my favor, but note you don't get much help with the materials in the app, which I did accidentally dropped here My phone was on the tile immediately after application and nothing…