TCMMRC FC F4 Flight Controller OSD 2-5S DSHOT600 for RC Drone FPV Racing - Upgrade your Drone's Performance! Review

There are no marks on the board showing positive and negative sides and instructions on the side where it is wrong. I burned my board to plug-in. I had 4 of these boards and they are all different. Be very careful when buying. They work well for the price if you don't blow them up with a plugin.

the word is good. It features a highly sensitive gyroscope, so soft mounting is a must. Also, some pins on the board are not documented, such as B. the port that seems to work neither inverted nor non-inverted. Some connections had to fall back to softserial as they don't seem to be working as documented.

I wish I had paid more attention to the wire harness they provided me, their quality control is not good and I burned the circuit board. I was hoping to get a deal on an older model of the latest board. They had it and I burned it because they put the wires in the connectors the wrong way, if they had had a piece of paper with instructions this wouldn't have happened

I keep buying these for building 5 inch quads. These are great F4 FCs that support many options. They work great with compatible 40A regulators and other regulators. I have a quad with AIO stack and a quad with F4 FC only with BLHeli 20A ESC for my girlfriend's quad, no problem, they were very easy to assemble. Will continue to buy ESC from these FCs.

This is a great flight controller. I've built about 4 or 5 good quads with it. 2.5" and 3". They're relatively easy to wire up as they have connectors and you don't have to solder directly to the board if you don't want to. You can also solder to the board if you don't like the connections. The only complaint I have is that some of them come with straps that are not silicone coated. If you try to solder these wires, the sheath will melt. I make all new tethers from leftover iflight tethers I…

4 stars because this thing doesn't have detailed documentation. Would I recommend this product? May be. Mainly because there is very little support for this brand and even if you find out that it is actually an Omnibus F4 V4 flight controller, it is still a bit difficult to connect. Does it do the job? Aha! Was the connection easy? Once I found the documentation yes. One important thing is there is solder jumper for RX to choose PPM or S.Bus. This is a very important solder jumper that you need

I'm not a drone expert. I have 2 that I built from scratch and they work as intended. I saw this controller and was excited about the built in ESC and power management and thought it would be good for my next drone. I opened the box and was amazed by the beautiful packaging. Came in a metal box with styrofoam cut out, has shock absorbing spacers for attachment but once I started inspecting it I realized something. There are 4 cables included, one with a connector on one end, the other three…

This is a replacement for the two Tyro shown in the title, it uses the same connectors as the original, so no soldering except for the SBUS receiver type. or PWN/IBUS, it also has an adjustable 5 or 10 volt power output for your camera, selected via the contact pad under the camera connector. This works with battery packs from 3S to 5S. Everything you need comes with this flight controller, all wiring harnesses (ESC, camera, receiver and VTX) and a set of 4 plastic and 4 rubber nozzles. If you…