🚗 Enhance Safety with TYC 18-1153-40: TOYOTA Driver Side Replacement Side Marker Lamp Review

Excellent device, I had to change the plug on it. This part had a square fork instead of a round one. No problem. I cut the round connector out of the old block and replaced it.

The base on these is actually rubber so hopefully they won't fall apart in the sun like the original units. Worked on my 1981 Toyota Dolphin.

Used to replace a broken passenger side light on my Celica Supra 83, I had to change the plug to make it fit but very minor work. Lights up and looks great.

It wasn't just a perfect fit. it is also made of soft plastic. almost like rubber. The OEM block burned under engine compartment temperatures and hot summers, becoming brittle and cracking once you hit some of those washboard desert roads. Great price too.!

My old markers have rotted, crumbled in my hands like a scene from a mummy, a few wires left. I tried to buy a used one but it was out of stock and couldn't stand the high prices in cruiser parts dealers. Tried Amazon for fun and found these. They are not as good as nla 24v units but more than a decent replacement for my truck. I installed a couple of LED bulbs and that's it.

I have a 1980 Toyota Corolla Tercel hatchback. Rammed the front left fender and had to replace this lamp. This part fits perfectly! However, if you are an auto noob like me, you should be aware that you will need to remove the fender to replace the entire kit. I haven't removed it yet, so I only replaced the orange plastic part of the bulb, not the sealing plate or the bulb socket and retainer.

I got driver and passenger side marker lights for my 1984 Toyota FJ60 Land Cruiser and I couldn't be happier. They contain all the necessary elements for their installation. They plug directly into the cable without any problems. The 20 minutes for both sides are running out slowly. Make sure you look at the back of the gasket, there is an outline that matches the shape of the tail light hole. I would buy them again in a heartbeat.

This is a well made product. It comes with bottom (RIGHT HAND or LEFT HAND), make sure you order the correct one. It also comes with screws and a quality water seal. They have a plastic shell from the factory that fits into the same trapezoidal hole in the sheet metal. The two I bought, both the RIGHT and LEFT, had the correct factory electrical connections (which also have a floor, passenger side, or driver side) but the plastic case was wrong. HOWEVER, this does not affect the installation…

This replacement light is as close to the original for my 1989 Land Cruiser FJ62 as you could be if it weren't sourced direct from Toyota. The lamp assembly was packaged well and included the diffuser, base/pigtail/plug, screws, spare nylon inserts that fit into the body holes and act as 'nuts' for the screws, and even the necessary bulb. The only notable differences to the original were as follows: 1. A real plus: the braid/connecting knot is at least twice as long as the original.2. One small