Motorcycle LED Flush Mount Turn Signal Light Indicator Pair - Universal Fit for Yamaha 🏍️ KLX250 YZ125 KX85 XG250 YZF-R1 YZF-R3 YZF-R6 YZF-R25 SR400 - Ideal for Sport Street Racing Bikes (Smoke) Review

They didn't fit my FZ-09. The base is a little clunky. You have to cut some of it. And even then, they won't sit flush with the factory base, which is why you'll notice the white backing of this light.

I had to modify it a bit but it turned out well. I had to cut off the stock rubber boot because. The native hole is too big for these turn signals. I installed them on a 2003 FZ1.

I had to cut the plastic retaining rings on the nuts to fit them but it was easy. No resistors or relays are needed to make them blink at an acceptable rate. Looks better than bulky regular turn signals. Easy plug and play cable installation.

Fairly easy installation on a 2015 Yamaha YZF R3. Remove the top faceplate just below the steering wheel and slide your hand down. It's not the brightest, but good enough to pass the test. No instructions were included, just make sure you keep the back wire together and the yellow and other color together. There is no hyper firmware with built in relay that comes with it.

They look a lot better than standard indicators. They are more streamlined and look great smoked. I have a few complaints that they come with no instructions, but you can search YouTube for "TST Industries FZ-07 LED Signals" to find a video on how to install them. My other complaint is that the included plastic washers don't fit very well, but you can get them to work. Note that they flash quickly without changing the turn signal relay.

Absolutely NOT UNIVERSAL turn signals. I have fz07 and they don't work. The first problem is that they are two-wire black and yellow wires. The fz07 comes from the factory with a 3 pin connector that connects the 3 factory turn signal wires. Well obviously 2 wires won't work because you can't have "low" running lights with bright blinkers and a ground wire with just 2 wires. The second issue is that the mounting system is not designed for the fz07 as it is too big to fit the small hole on the…