🔌 20PSI Electric SUP Air Pump: Efficient Car Connector Inflator for Paddle Boards & Boats Review

I have a very large iSUP (Blackfish V model). This pump works great and takes a long time to reach 17psi. That's not a criticism, because I'm pretty sure it's just faster than comparable devices. Just remember that you should start inflating as soon as you arrive at the launch pad. My board takes 10 to 15 minutes.

Works as advertised. However, the tube is so super stiff that it is very difficult to attach it to my paddleboard. Because it's difficult to attach, it also appears to be loose, meaning air is leaking out. It's a little frustrating. Also, my girlfriend and I competed to see if she could fill her board up as fast as I could with an electric pump. Guess the same time unfortunately.

I really like this pump. I can connect it to my surfboard and leave it there. After a few minutes it's fully inflated to the correct PSI and I'm good to go. Please note that this is a 12V pump, so the only power source is your vehicle's 'cigarette lighter', which is a 12V socket that cannot be plugged into a normal household socket. I have used this pump in various vehicles and have had no problems. The cord and hose are quite long so you can easily reach the board outside of the car.

It was really easy to use straight out of the box later on we needed a new roof like I said it broke literally plugged in and comes with a range of different attachments for each job delivered can do. Use it because we need to go straight back to the fitness ball and it made it so quick so easy just plug it in when I need a hatch pop it in the ball and literally seconds later the ball settled down. It is much easier than trying to smash things and small enough to be able to put them where it…

I bought this for my surfboard. It took 12 minutes to fill my 11 foot board. Stopped at the exact 15psi I set it to. The hose is a bit stiff and not very flexible. This is the third electric pump I've tried. Connecting the hose to the air intake is a bit tricky to secure. I switched to a different o-ring size that it came with and it works, you just have to push hard and then twist and it tightens. Starts quietly to 7psi, then gets louder until the end of the fill. Generally inflates to the…

I've read reviews of other products that take 15+ minutes to inflate the board and was only prepared for the simplicity and cost-effectiveness of this pump, but I was pleasantly surprised , when my The 10.6 SUP inflated to 17psi in about eight minutes. In drain mode, it took about 90 seconds to fully drain. The chords are long enough for the board to be in the back of my SUV and still connect to the dash in the front. I only filled out one board so can't speak of using two or more at the same…

After struggling with MANY pumps for my SUP I finally decided to bite the bullet and pay a higher price for this one. And it was worth every penny! It runs VERY fast and fills 2 paddles without overheating. Very glad I got this! A tip: the rubber stoppers (the white little grips that came with the pump to make sure it connects to the paddleboard and stays in place) didn't fit my SUP, but mine came with my own hand pump - I have the rubber simply remove Stopper from the hand pump and slip it…

It pumped my 4x6 board to 12psi in 12.5 minutes. On this board, two people typically swap hand pumps for 15-20 minutes. Switch on, operate intuitively, switch to psi, set limit to 12psi, plug in and press the power button. Easy. It started pumping at low pressure, not too loud, and I let it build to about 1psi and then decided to switch to high pressure. At this point it was pumping air much faster, but it was quite noisy. Can't say I really care as it made inflation plug and play instead of…