🔌 Weego JSOBD-1: OBD II 12V Memory Saver, Settings Keeper with 5mm Barrel Jack Output Review

Connected this to my bike because the battery compartment makes it very difficult to get to the positive terminal when I want to start the bike. Tested with a non-Weego launcher and it works great. That being said, I'll probably go with the Weego starter because it's a bit smaller than the one I have.

I think it's a DC barrel connector (5.5mm OD x 2.1mm ID) used for some accessories. leave nests. I have a DBPower jump starter and it plugs into the auxiliary socket. However, the power indicator does NOT come on until I jumper the chassis ground pins on the data link connector when I am not in the vehicle. Tomorrow I'll try to use it and we'll see if the LED stays on after disconnecting the car battery. If I jumper the chassis ground pins I see power (12V) on pin 16. If this works on the car I

Here is a copy of the response I received to a question about using it on another brand. clamping end). One of the images on the product page shows a very close up close-up of an EC5 connector. Some brands specify the type of plug used, while others do not. Our cables work with the Weego JS12 and Weego JS6 models. only."The first sentence says it will work with any product with an EC-5 connection and the last sentence says it will only work with 2 specific Weego models. The best I can say is…