🎣 YGS-Tech 24W UV Black Light LED Strip, 16.4FT/5M 3528 300LEDs 395nm-405nm Non-Waterproof Blacklight Night Fishing Implicitly Party with 12V 2A Power Supply - Enhanced SEO-friendly Product Title Review

Excellent light strip for resin curing. I use it for curing 3D prints, but I think it will work well for most photosensitive resins as well. Keep in mind that they give off a decent amount of heat when closed.

It offers incredible performance in an easy to use package, with double-sided tape already applied to the back. I used this strip to make a UV curing chamber for resin prints. I highly recommend it for this purpose.

I bought these to cure UV resin pieces. Maybe it's the nature of the beast, but it seems like they take a long time to get the job done. I had to leave the pieces overnight before they fully healed. I don't worry too much about this because I can just leave them and go to bed and come back to perfectly set pieces in the morning.

Got these to make a curing chamber for UV resin casting (not for 3D printing). I couldn't get a solid cure for her even after several hours. The gel polishing lamp perfectly cures the same resin in 2-3 minutes, so I'm not sure what's wrong. Other people seem to have successful cures, so maybe I was just unlucky. My issue aside, this strip is a reliable product.

Simple product. It's hard to go wrong, and rightly so. Easy to use, you can leave it as a whole strip or cut it into smaller pieces and solder them together. Comes with a wall mounted power supply. I'm still waiting for my printer so haven't had time to use it yet, but everything looks fine. Be careful when you look directly at these things, they are pretty bright! Near-ultraviolet light is likely bad for your eyes if you stare at it for too long.

bought this for a curing station for my resin 3d printer and it works great. and then these headlights lined up on it. I have a clear stand that I place the print on and then put a bucket on top and the whole print hardens in a few minutes. I'll definitely have to put this on a timer as I've found it will burn/turn yellow/white resin if you leave it on for too long. However, it is not as durable as other kits that can heat or warp prints during post-curing.

I bought these to make a box for UV curing resin 3D prints. I cut them into 9 LED strips at every third seam and then attach them to the inside of the box I made. I then soldered the wires from the connector to the strips. So far, so good. The only issue I had was that there were multiple joints along the entire length of the strip that were soldered together. It is evident that these ligaments are made up of several shorter ligaments. That meant I couldn't just cut them with scissors. Instead…