I used a fairly thin piece of glass for the bed that I had cut out at a local glass shop. Everything was fine with the glue stick. Nothing special or anything like that. Enter this product - I figured I needed a thicker piece of glass that would accommodate the warping of the aluminum platform a little better than the thin piece I had. The special coating, which should adhere perfectly without glue or hairspray, lured me to the much cheaper mirror tile. Arrived a few days after ordering. After placing it on the aluminum platform, preheating the nozzle and platform, attaching the glass to the platform, and leveling the platform with a piece of standard printer paper, I began with a simple small rectangular print. Immediately in the first layer, the print came off by itself. I tightened the layer on the printer again using a piece of standard printer paper (only thicker this time). Printing quickly failed again. I adjusted my level and did it three or four more times. I rinsed the glass platform with water as instructed (and of course I had already removed the protective film) and made sure everything was properly installed and aligned. Even with casts too close to the bed, they came off too easily and too soon. Finally I used good old fashioned glue and the prints held up well. 2/5 Because it's a thicker piece of glass than you might like, or at least comparable to a mirror tile. But save yourself the hassle and money and buy 6 packs of mirror tiles at the hardware store and use a glue stick. This special coating does not improve adhesion.
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro โStraighten And Stretch For Enhanced Performance
50 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
High-Precision And Stable Creality Ender 3 V2 3D Printer With New UI, Silent Mainboard, Effortless Filament Feed-In, XY-Axis Tensioner, Resume Printing, And Large Build Volume Of 220ร220ร250Mm
11 Review
Economic Ender 3D Printer DIY Kit With Resume Printing Function, Large Printable Area Of 220X220X250MM By Creality 3D
18 Review
๐จ๏ธ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review
๐จ๏ธ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review