🖨️ Creality 3D Tempered Surface: High-Quality 310X310X4Mm Printing Bed Review

I bought this for my CR-10. Although I assembled my printer exactly as directed without over-tightening anything, the platform it came off of was far from level. The supplied clear glass was actually a problem. This bed solved my pumping problems immediately. It should be noted that this bed is slightly thinner than the glass bed that comes standard with the CR-10. At least for my standard bed it was about 1.5-2mm thinner. Its adhesion is excellent. I use 90% IPA after each print to clean it…

I used a fairly thin piece of glass for the bed that I had cut out at a local glass shop. Everything was fine with the glue stick. Nothing special or anything like that. Enter this product - I figured I needed a thicker piece of glass that would accommodate the warping of the aluminum platform a little better than the thin piece I had. The special coating, which should adhere perfectly without glue or hairspray, lured me to the much cheaper mirror tile. Arrived a few days after ordering. After…

I had a CR10 and used the Peopoly print surface I got direct from them which was pretty good but became less effective over time. When I replaced the CR10 with the CR10 I got a different peopoly printable surface but through Revain and it didn't seem to work as well as the one I had before. I eventually got so frustrated with this that I went back to tape and glue stick, but it didn't take long for me to remember why I was trying to find alternatives to this method. So when I was looking for a…