Review on 🔧 Premium Replacement Carbon Brush Holder Brush Card Assembly for M18 18V Hammer Drill & Impact Driver – AEG Milwaukee Compatible Accessories by Bhanu Hays

You use very small, very short screws to attach each of the two wires to the brush set holder. One of the wires broke off at the end of the wire where it was crimped and I had to re-solder it. I did the same with the other wire as well, so I knew it would be secure during assembly. Also, one of those little screws was missing and I had to find another screw that would fit. The wires are a little longer than the OEM part, but they hide nicely under the trigger switch if you don't shorten them too much.