Review on Enhanced Flexibility with 💪 Creality Original Magnetic Removable Base by David Dreher

Adhesion is pretty good, easy to install and use, but after about 15 prints a large piece just peeled off. I'm not sure if that's common, but I hope not. Update: Got the 2nd after returning the first. My printer wasn't working when it arrived so I had it for a few days before using it but now it's only a week after I received it and it already ripped and peeled off after about 8 prints, and i had problems with all the time. It stuck well, but too well. With layer temp at 60 and PLA at 200 it actually even stuck the bottom magnet to the magnet stuck on the table but only right under the print. I literally had to lift it off the bed before I could start removing the pressure from the surface. Now there is no option to return or refund or anything so I think I just had my money drunk. As you can see in the picture you can see it leaves a layer of PLA (I tried 3 different colors to make sure my filament wasn't the problem). I didn't use anything at all, no alcohol, not even water. This is probably only good if you're doing prints with a large contact area or raft and still cleaning it evenly while it's still hot. If you're doing small parts or anything, don't use it.