🔧 Stop Leaks with ABN 1/4in NPT 360 Degree Swivel Connector: Adjustable Tension Control, Perfect for Air Tools Review

Spins and works well with the collet. But that's where the benefits end. The 1/4" inner diameter restricts airflow so much that I can't even use a tire clamp on a compressor that produces 8 cfm at 90 psi without turning off the compressor.

I bought 4 of these last year and 3 of them were fine. I recently bought one that was not drilled properly and would not allow air to flow through the fitting. After I removed the locking ring, slid it apart and drilled out the part, everything worked fine.

Product works mostly as described. The internal threads were on the small side. I couldn't make many turns on my or any other fittings. My biggest complaint is that the fitting leaks out of the swivel when little pressure is applied. It's not a major air leak, but a leak nonetheless.

Bought three. I installed everything at once. This lasted less than five minutes. The other two are still working. It was a lemon. Rough drilling in the pivot block resulted in an oversized and probably slightly warped hole. This elongated and deformed cylinder, drilled into an aluminum block, does not seal properly with O-rings and the retaining ring does not match the end stopper clip diameter. Due to the tolerance set, the block expands during use beyond the specified "stop" at "factory…