🚦 AT-HAIHAN Pack of 2 Aluminum Housing Red LED Trailer Stop Brake Turn Tail Lights: DOT Compliant Waterproof Lighting for Truck Tractor Jeep RV Review

The reason the turn signal LEDs are the same as the travel LEDs is because the travel LEDs are too bright. I made a simple solution by adding a 100 ohm 1 watt resistor in series with the black line. I reduced the current from an amp to about 1/2 amp, which brought the brightness down to a level where you can see a normal turn signal. You can increase and decrease the resistance as you like

Small, low profile but high brightness. Excellent instructions included, very detailed. Only two minor complaints, the wires are too thin. They are LEDs with minimal gain and power consumption, but the smaller gauge wire is difficult to connect to the pendant's existing wire gauge. Another complaint is that the OEM doesn't have a lock washer or nylon lock nut. Overall I'm happy with the product, I hope they last without problems in the future.

I used these trailer lights to replace the large square and broken bulbs that came with the trailer. The lights are attached to a steel bracket behind the fenders of this trailer. They are in a vulnerable spot due to their location and have been bumped or kicked many times while loading and unloading the trailer. These LED lights mount flush to the face of the corner, allowing you to use them as a step and not obstruct the light. Despite their relatively small size, they are brighter than the…

The product looks good and has a very low profile, which is what I was looking for. Most trailer lights are oversized and can be damaged. Installation would have been easy if the wires had a wiring diagram or simple labels, but nothing was included. So you need to check what the tail or brake/signal lights are. In addition, the washer connector on the cable has been pre-crimped so it doesn't go through the center mounting hole where the wire harness can slip through (required for a flush mount…

No brake lights and turn signals. You can use it that way, but here's the rub. If you have low power (like tail lights), if you have high power (turn signals or brake lights), the high power will not work. They cannot work at the same time. I bought these for my tractor to mount on the back of the fenders. I keep turning off the lights when cleaning the pig with branches. It hangs on the side of the tractor. After you have made the mounting plates and installed them on the tractor, connect them

AT-HAIHAN DOT Compatible Waterproof LED Surface Lights: good solid lights with aluminum base plate. Beautifully made with clean finish and casting. Comes with zinc plated mounting bolts and nuts. Requires two end mounting holes and a larger 1/2" center hole for cable routing (easily accomplished with an inexpensive Harbor Freight step drill). All LEDs illuminate in both tail mode and brake/rotation modes. Design dissipates intense heat from light ones LED bulbs down to extend life - they run…