💦 Aqua Tec 8852-2J03-B423 Aquatec CDP 8800 Water Booster Pump + Transformer 115V 1/4 & 3/8, Black: Powerful Water Pressure Enhancer for Optimal Performance Review

Before: PSI: 34TDS: 18(well water TDS: 278 This pump works: PSI: 80 (adjustable to 120) TDS: 4 The only thing I need now is the automatic flush valve on the water side product to get the To reset TDS creep I open it manually for less than five minutes and watch the product water value go from 45 to 4. Osmosis After flushing the effluent side I recommend flushing the product side for a few minutes to bring the tds down, especially when You use DI A built in tds meter is really helpful.

Great Pump! My inlet water is 45psi and with this pump the inlet pressure goes straight up to 120psi. The pressure is easily controlled by simply modulating the flow rate. Increasing the flow will decrease the pressure since the flow (cfm) of the pump is constant. The manufacturer is designed for 200GPD cones, but I use it with a 300GPD cone without any problems. My diaphragm TDS output has dropped from 66 to 7. Great. Almost silent operation of the pump, but in the hoses (especially at the…

Bought this pump to pressurize my reverse osmosis system so I can pressurize my holding tank and improve fridge fill speed. While the pump is doing all of this, it seems to be quite noisy. It doesn't seem too bad in the room itself, but I bolted it to a 1x6 that's bolted to the concrete wall under the house with a reverse osmosis unit. When it's on I can see it at 40 feet on the main level, it's not loud but it's a noticeable buzz that wears you down the moment you see it. Double checked and…

Used to run 100 g/day membrane / 800 ml/m effluent limiter at 120 psi. Works great and isn't very loud. Most people having trouble with this pump are using it incorrectly or not understanding the pressure and flow ratings given in the data sheet (available on the Aquatec website). It's relative to the inlet, that's how the pumps work. Total boost pressure is also adjusted by a hex head screw on the front of the pump; Setting it too low will make it noisy, but that just means this pump is too…

This pump is able to provide the necessary pressure for my reverse osmosis machine which I use to make maple syrup. The mount is excellent, helps reduce noise and the pump itself is quiet. It works in any position, but upside down it's said to decrease efficiency in removing air from the line, but I didn't notice a difference. It also has a second use, a vacuum pump. It's not very powerful, but there's enough vacuum to double the amount of sap coming out of the trees. When the vat is full I use

I have used this pump for 9 months on a high pressure aeroponics machine set at 100psi. It was exactly as advertised with very low noise levels and self priming capability. However, I noticed last week that the pump was making a squeaking noise and today the pump just ran non stop but spilled the entire tank onto the floor through the outlet and drained (left behind) my pressure tank. connected the pump switched off. I opened it up and found a small hole in the triangular diaphragm that allowed

I bought this for my RODI setup. Thanks to one of the reviews, the first thing I looked for was the adjustment screw. it was there Next thing I did was turn the pump on for a few seconds with no water connected - some musty smelling water came out after factory testing. No problem. I was able to wash it easily. Since one of the reviews warned that the factory pressure was set too high, luckily I hooked it up to my RODI setup and only turned it on briefly to see my peak reading. ! Corrected by…