Revitalize Your Cabin Air Filter with K&N's Cleaning Kit: Sprayer Bottle Cleaner & Refresher Kit; Enhance Filter Performance; Service Kit-99-6000, 99-6000AMZ Review

The filter was noticeably cleaner after the first use and even better after the second. This is a project that takes about half a day. Two uses of the cleaner will take approximately 30 minutes (remove filter, apply cleaning solution, leave for 10 minutes, rinse until water runs clear, then repeat). Next you need to let the filter air dry, which took several hours. Applying the oil was easy, however each application of oil needs to be left on (about 20 minutes) to allow the oil to penetrate the

I want my K&N air filter serviced every 20,000 to 30,000 miles and that's exactly what I need. The cleaner removes old oil and any contaminants that have built up in the filter after a short soak and thorough rinsing with water. Be sure to wear gloves when using the cleaner as skin contact is not very comfortable. Once the filter is dry, the oil spray bottle makes it easier to re-lubricate the filter. You'll get less oil with a spray bottle than the spray bottle offered by K&N, but it's MUCH…

I am new to K&N and have had my intake system installed for two years and figured every 50k or 100k would be perfect. Well I've noticed that my truck has been losing power over the last few months and as a result I've found that when my filter is no longer red it needs to be cleaned. God I felt stupid but I cleaned it last night, be aware I had to do 2 cleaning cycles due to excessive build up. I oiled it after letting it dry for 8 hours and just applied it this morning. WOW! My trucks are…

Pretty straightforward. You will be given a cleaner and oil to restore the filter. Clean until water runs clear, let dry, spray on oil, reinstall. Most cabin filters are around $30, which is about the same as a new K&N. So this conversion kit should last 3 or 4 years and you typically clean this filter once a year as needed. For a filter and rebuild kit that costs about $40, after 4 years expect to be about $10 a year. After 8 years $5 per year. After 16 years $2.50 per year. It's quite a nice…

Yes, it works great :) It's very easy to make, the only thing that takes time. Good time :P You just have to wait for the cleaners and oil to take effect. This has restored the filter to its original condition and is working incredibly well :) Step 1: Apply Cleaner Spray K&N or K&N Power Kleen Air Filter Cleaner liberally to both sides of the filter and leave for 10 minutes to remove dirt solve. Do not allow cleaning agents to dry on the air filter. Step 2: Flushing the Filter Flush the air…

A must have if you have a K&N air filter. I've had the filter on my s2000 for about 40,000 miles and should have done this cleaning a lot sooner if I knew it was that easy. The included instructions are simple and easy to follow. Little can go wrong here. I sprayed the cleaning solution (pump bottle) on very generously and rinsed it off. I've done this cleaning step twice and probably have enough left to clean the filter at least 1-2 more times, although I'll probably only change the filter…

love the pulp bottle. The aerosol can is simply sprayed everywhere and it is more difficult to control the amount and target. It also seems harder to tell when you've applied too much or too little. Using a syringe, simply apply an even amount of oil along the ribs on either side of the filter, allowing time for the oil to soak into the filter fibers. Filter. That way you can start with less and if "soaking in the middle" isn't enough, you know you need more and can judge how much more remains…

First time trying to clean my K&N filter with this system and the results are good! It's basically a four step process using these two products: 1) Remove the filter and spray the Power Kleen solution "plentifully" onto your filter. 2) Rinse off the Power Kleen solution with running water. (Instructions say you may need to repeat these steps, which I did.) 3) Shake off excess water and allow to dry completely 4) Spray filter oil on filter - allow to dry 20 minutes - reinstall. That's all. came…