🖨️ Creality Makerbot Extruder 3D Printer Review

First, the standard nozzle for Anet had an 8mm hex and this one 6mm. With the extra material in the 8mm nozzle you get better heat and the tip is larger and flatter for a smoother result. Second, these nozzles do not indicate size! Third, filament flow is a problem, and this can be due to hole diameter changes, as noted by other reviewers. Look for something better that could mean something other than Revain (sorry Revain).

These tips differ from the original tips that come with the Creality Ender 3 Pro. These jets are worse. You'll understand this once you put it on and see the incomplete extrusion and digging in the top layers of the print. They differ in the following points: 1. The face of the hexagon is shorter, which increases the angle to the nozzle tip, which reduces the heat capacity of the nozzle. Nozzle tip is sharper3. Tip hole diameter is smaller.4. The nozzle tip has a smaller flat area.5. The tip of

I ordered them for Anet A8. With these new nozzles, I ended up having clumps of material on my prints. On my printer, the outside diameter of the chamfer on the aluminum block of the hot end is larger than the flat-to-flat distance on the nozzle, which allows material to ooze and drip onto my prints, rendering them unusable. The original nozzle is 5/16" (8mm) above the flats versus 6mm on these nozzles. If these are regular nozzles then the buyer should beware but I have only resolved this…