🔧 Dremel MM502 1/16-Inch Grout Removal Oscillating Multi-Tool Blade, (1-Pack) - Suitable for Bosch, Makita, Milwaukee, and Rockwell Review

This blade was very good at gouge removal. I used it in my Rockwell Sonicrafter F80 tool. I had a tile around my countertop that I needed to remove and I mainly used this blade to cut the tile off the counter. It worked very well

They worked great. They fit perfectly in 1/8 and 1/16 if you are very careful. Other 1/16 blades I've tried were too thin, but these were thin enough to get the job done. They wear out pretty quickly when cutting joints, so I bought a couple to shower with.

When choosing a 1/16 inch gouging blade, remember that there are different model numbers that correspond to different prices and quality levels. I accidentally ordered this model MM502 and the blade isn't deep enough for the job. Study this carefully.

When I received the blade I was very surprised to find that there was very little carbide and only on the very tip of the blade. The blade itself is very thin. Decided to give it a try for a 1/16 > 1/8 inch wide grout on a bathtub ledge. WARS! The hard metal at the tip of the blade wears out very quickly! Disc Dremel Multimax 501U 1/16 VERY GOOD. The Fein 1/16 Carbide Grooving Blade is also very good but much more expensive than the Dremel. XXGO 5pc 1/16 is cheapest but XXGO blades are very…