🎯 Enhance Precision and Efficiency with Kreg KMS7800 Solid Production Stop Review

This falls on a Kreg KMS7704 Heavy Duty Trak. Clamps firmly and securely. There's no need to over-tighten the grip like others do. However, if you rip it off, you can always drill and cut a hole for a larger screw. If using this with a homemade fence you will need to match the top profile of the fence to the Kreg Trak profile. If you don't do this and just use a straight board, the stop will be about 1/4" from the stop. It doesn't matter for straight cuts, but the beveled edge can slip over the

I use these production fences along with the Kreg Top Guide on my miter table for repeat cuts without measuring. They work well, but they definitely need improvement. My first criticism of these fences is that they don't even touch the fence, and since my miter saw fence is always at a 90 degree angle to the work surface, that means the fence doesn't even touch the work surface. Since it's just a stop, the only surface that needs to be flat has to be that next to the wood I'm cutting, but it's…

I've been using a Kreg Swing Stop for a while. This is a great product and the ability to remove the stop on the side proved to be a lot more useful than I expected. However, as other reviewers point out, it has very little to play with. If you cut to any fixed size you can slide all the pieces in one at a time and slide the gap out of the fence, but unless you've lined up the tape measure carefully you can't be sure the fence will fit exactly where the indicator says on the band is. Still an…