Enhanced Magnetic 196X126Mm Flexible Printer (7 7X5 Inch) Review

As expected I had to sand the surface with sandpaper as the first test print after installation as the print would not adhere to the surface. surface of the new assembly. I sanded lightly with 180 grit paper and the next test print worked great. To ensure proper adhesion of the magnet to the original build plate, I cleaned the plate with about 99% IPA, then sanded very lightly, then cleaned with IPA again, then used 4-bar clamps to hold the magnet in place for 72 seconds to keep the original…

After cleaning my Elegoo Saturn bed with alcohol. I applied the magnetic tape and let it sit on the table for 20 hours before printing with a clear red water washable resin with a bottom exposure of 25 seconds and a normal exposure of 3.25 seconds. The first print was three helmets with a height of 55 mm. Two of them got stuck, and the third, which was closer to the right side of the bed, stopped sticking after a couple of hours and fell into the bed. The bed was set up and leveled so it was…

Update: Even though the prints do finally stick, larger horizontal prints deform the build plate and pull it away from the magnet during printing. (see images with red squares highlighting the problem). This also warped the print. I don't know if this is specific to these flexplates or just this brand. You can grit your teeth and grab one of the tried and true flex sheets. Works with modification (no need to do this. The manufacturer should be aware of this issue) ), magnetism detected (no, see