🖨️ SIMAX Ceramic Cartridge 3D Printer Review

The thumbnail shows the cartridge is packed separately, which is very important to me as I run a 3D printing farm, you just have to pick and go. The products are supplied in 5 cartridges, all packed together. So if you try to pull out a sticky cable, it will pull out the entire cable and make a huge mess.

wish i could give it 5 stars just felt like it could be a little longer. But it heats up nice and fast. Good stable temperature and no temperature fluctuations were observed. I lost about 3 inches from z and x because the cord is too small to get maximum reach and I don't want to risk an extension cord.

I did a quick comparison before installing the cartridge. Use a 12V/40W box and this 24V/40W box. The 12V block measured 4 ohms, the 24V block measured 13.2 ohms. A quick calculation showed that 12 V theoretically does not reach 40 watts, but only 36 watts. While a 24V block at 43.6W is slightly higher than 40W. Again, these are theoretical values, but they should be very close to the real world. The only thing that will affect the values is the power supply and if it's right for the money like